To Next PageTo Next Page
Need help?Do you have a question about the Triad InRoom Platinum PowerSub and is the answer not in the manual?
Controls the gain of the subwoofer amplifier using the left and right inputs.
Two independent 12dB/octave low pass filters for combined 24dB roll-off.
Adds up to 180 degrees of phase lag to improve subwoofer-to-speaker blending.
Inputs for increased frequency response below 35Hz and use of level/high pass controls.
Fixed input level for maximizing output above 35Hz, bypasses Input Level control.
Provides a fixed 12dB/octave high pass signal at 100 Hz for main speakers.
Converts speaker level from receiver/amp to line level for PowerSub inputs.
Cabinet width 13 1/2", height 14 1/4", depth 13", shipping weight 40 lbs.
Cabinet width 15 1/2", height 16 1/4", depth 14 1/2", shipping weight 70 lbs.
Cabinet width 17 1/4", height 18 1/8", depth 15 3/4", shipping weight 76 lbs.
Cabinet width 14 1/4", height 19", depth 3 15/16", shipping weight 24 lbs.
Cabinet width 14 1/4", height 19", depth 5 15/16", shipping weight 24 lbs.
Cabinet width 13 1/2", height 13 1/2", depth 9 1/2", shipping weight 20 lbs.
Cabinet width 14 1/4", height 19", depth 14 1/2", shipping weight 61 lbs.
Adjusts the lowest frequency the speaker will play, with THX setting reference.
Adjusts loudness to match front speakers or satellites; use THX mark or MIN for multiple subs.
Sets the highest frequency for blending with satellites; use THX mark for THX settings.
Adjusts signal timing for musical blend between sub and satellites, typically 0 or 180 degrees.
Connects to the 'sub out' from a THX Processor or THX Receiver.
Connects to RCA jack inputs using pre-amp out from processors/pre-amps.
Converts speaker level to line level for use in PowerSub's line level inputs.
General