• It is prohibited to carry out any modifications to
the appliance without prior written consent from
Triangle Tube.
• Faulty parts must only be replaced by genuine
Triangle Tube factory parts.
• To prevent damage to the inner tank, the Installer
must:
– Always fill inner tank prior to outer tank and always
drain outer tank prior to inner tank.
– Relieve primary system pressure below 15 psig
prior to draining inner tank.
• Failure to comply with these instructions can result
in minor property damage, or injury.
• Protection must be taken against excessive
temperature and pressure! Installation of a
Temperature & Pressure (T&P) relief valve is required.
• Failure to comply with these instructions can result
in minor property damage, or injury.
CAUTION
CAUTION
• In case of any anomaly, please call your qualified
service technician.
• Make sure to reference the unit’s model number and
serial number from the rating label when inquiring
about service or troubleshooting.
• Triangle Tube reserves the right to change the
technical characteristics, components and features of
its products without prior notice. Check for an updated
version of this manual at www.triangletube.com.
NOTICE
viii
SAFETY
PRODUCT AND SAFETY INFORMATION
To Next Page
Loading...
