TRIATEK HMS-1650 - Page 2

Due to continuous improvement, Triatek reserves the right to change product specifications without notice.
CONTROLLER SETTINGS
HMS-1650 Fume Hood Controller Settings
HMS-1650
- 2 -
Fume Hood Name / Number
Unit Model Number and Serial Number (ESN)
This form should be completed during the initial configuration for each fume hood controller. See HMS-1650 Installation Manual
for details.
Network Setting
Address
Device ID Offset
Baud Rate
Setpoints
Sensor Input Range (zero-based or offset)
Occupied Mode Setpoint
Unoccupied Mode Setpoint
Standby Mode Setpoint
Analog Output
Operating Mode (Direct or PID)
Analog Output Range (zero-based or offset)
Analog Output Upper Limit (0 – 100%)
Analog Output Lower Limit (0 – 100%)
Analog Output Input Channel (AI-1 thru AI-4, TI-1 or TI-2)
Analog Output Action (Direct or Reverse)
Analog Output Range (zero-based or offset)
Flow Range (Maximum)
Flow Range (Minimum)
Sash Switch
Operating Mode (normally-open or normally-closed)
Delay Setting (0 - 240 secs)
Relay Output
Trigger Mode (Setpoints, Operating Mode or Timer-based)
Triatek reserves the right to change product specifications without notice. Triatek reserves the right to change product specifications without notice.