9 | P a g e
TRIDENT AIR PLUS
FILTER ASSEMBLY
4 pre-assembled filters are included with this purifier. After the filters are
inserted, please close the rear cover to turn on the machine.
1. CLEANING OF ALUMINUM MESH PRE-FILTER
Depending on the environment in which it is used, the pre-filter needs to
be cleaned at least once every four months. It captures big particles >5
microns and also hair and tiny insects, etc
• Use a vacuum cleaner to get rid of any dust or fluff.
• Apply mild detergent and wash with a shower head.
• Rinse the filter well to get rid of any remaining soap.
• Air-dry the filter.
2. CLEANING OF A.G.E FILTER
• Remove the A.G.E filter.
• Place it in water with mild detergent and let it soak for 5 minutes.
• To eliminate all dirt, use a shower head to spray clean.
• Use a hair dryer or leave under sun to completely dry filter.
3. CLEANING OF OZONE DECOMPOSITION ACTIVATED
CARBON FILTER
• Use a vacuum cleaner or soft brush to brush dust off the filter.
• Do not wash under water.
4. CLEANING OF TRIDENT ION ACTIVATOR
• Gently unscrew the quartz tube.
• Remove the wire mesh on the quartz tube: if it seems to be difficult,
rotate the net slightly on the quartz condenser.
• Clean the quartz condenser by using a moist cloth. WARNING: Do
not use detergents, soaps, or similar products.
• Check whether the condenser shows any cracks or other damage.
If so, replace it.
• As soon as a whitish layer appears on the metal grill inside the
condenser, it means the tube should be replaced.
• Reposition the metal mesh on the condenser, placing it over the
internal grill. Leave a minimum distance of 6-7mm from the bottom
of the condenser.
• Check that spring tab touches on the wire mesh and pushes in
against the glass of the quartz tube.
WHOLE MACHINE CLEANING
• Clean with a damp sponge or cloth.
• Do not immerse the air purifier in water.
To Next Page
Loading...