Included:
Aluminum Trigger Mount
4 x 6/32 screws and nuts
2 x 8 mm hex head Bolts
2 x flat washers
NOTE: Route wires as required depending on installation requirements.
Advanced Accessory Concepts Corona CA 951-339-1469
Part # 2018 4 Runner
2002 - current Mount
Installation:
1) Place the flat washers on the 8 mm bolts and insert into the mounting holes on the mount. NOTE: It can be
difficult to install them once the Trigger is in place.
2) Use 6/32” screws/nuts to install the Trigger on the mount.
3) Install mount/Trigger onto the factory holes under the hood just behind the fuse box. See picture below for
location detail.
Note: for 2002 to 2009 it may be necessary to flip the bracket over so the Trigger is higher in the engine bay.
Trigger Controller
Not Included
To Next Page
Loading...