The vehicle must be positioned in its standing position to mount the handlebars.
We recommend that you lock the parking brakes before putting on the handlebars to keep
the vehicle stationary during installation.
Position the handlebar with brake cables ahead. See pictures below for reference.
Note: The throttle cable is attached to the right brake cable.
Loosen the two screws on the handlebars stem with 4mm allen wrench provided. Slide the
handlebar stem (with handlebars pre-attached) onto the top of the steering post and
tighten the two screws. The top bracket should be flush with the top of the steering post.
Align the handlebars perpendicular to the front wheel (or parallel to the axis of the front
wheel). Once positioned, tighten the two screws evenly. The final torque should be given
after the alignment is correct.
Trikke EV Owner’s Manual - V5 06/30/14 - page 8
Step 2: Mounting the Handlebar
LOCK
LOCK
Step on the vehicle, in riding position,
hold it with both hands on the
handlebars and look down the front
tube. Adjust the handlebar by aligning
the axis of the front wheel with the
handlebars (you may need to loosen
the bracket screws to adjust the
alignment of the handlebars if they are
tight).
Aligning Handlebars
To Next Page
