EASyCAST - Installation Manual
11
Please read the following information regarding the installation, setup, and configuration for the
EASyCAST Encoder/Decoder.
• The EASyCAST Configuration Software provides a much more comprehensive and
intuitive setup than is possible with the device’s front-panel setup feature, and is the
preferred method for configuring the EASyCAST Encoder/Decoder.
• Software configuration manuals for the EASyCAST are available at www.trilithic.com. An
update to this EASyCAST Installation Manual may also be available through the website.
• Additional application-specific instructions are available at www.trilithic.com.
• An EAS-Recommended Practices section is available in the appendix of this manual
which may be helpful in understanding the duties of an EAS operator.
• Make sure the encoder/decoder time and time zone are correct. EAS messages are time-
stamped and may be ignored if the encoder/decoder’s time is incorrect.
• The firmware (internal operating system) of the EASyCAST Encoder/Decoder is
upgradeable using a personal computer. Check the EAS downloads section at
www.trilithic.com frequently to determine if new firmware is available. Check for new
firmware prior to using the equipment, as some EASyCAST Encoder/Decoders have been
warehoused by distributors or end users and may not have the latest firmware.
• Before configuring the EASyCAST Encoder/Decoder, initialize it to the correct default
configuration. This is not necessary if using the configuration software to set up the
component.
• Stations that use the internal character generator video input should ensure that the signal
inserted complies with RS-170A NTSC specification in order to prevent synchronization
problems with the character generator. Some computer or VCR video sources may cause
video synchronization problems.
2. Important Information
Chapter 2
To Next Page
Loading...
Need help?
General