Trimax S3 - Page 2

2
Procut 237 has a special SLOTTED
Idler located near the Gearbox Pulley.
Loosen this Idler by slackening the
Mounting Nut, then unwinding the
M12 x 150 Set Screw.
Note:
DO NOT remove Idlers!
Remove ALL Vee Belts and place to
one side for later re-fitment
Support the weight of the Gearbox
Assembly.
Undo and remove the Gearbox
Mounting Bolts highlighted.
Place the fasteners to one side for re-
use.
Slacken this
Nut first
Then
unwind the
Set Screw