You can leave the lightbar connected to the cable when it is turned off. It may draw a small amount of current, but
it will not drain the vehicle battery.
If the lightbar loses power but then receives power again within 15 seconds, for example when cranking the
vehicle starter, the lightbar will turn on automatically.
Connecting a Coverage Switch
To install the coverage switch, refer to the instructions provided with the coverage switch.
Enabling the switch on the lightbar
From the main guidance screen:
Press until you have selected the icon.1.
Press . The Configuration screen appears.2.
Make sure that the User Mode field is set to Advanced.3.
Select System / Guidance. The Guidance screen appears:4.
Select Coverage Logging and then press . The Coverage Logging screen appears:5.
Press until you have selected Switch and then press .6.
If necessary, set the user mode back to Easy.7.
Coverage logging is now set to start when you press the switch.
11