ITEM DESCRIPTION
The master line that you created, and that the swaths are based on.
The A (start) and B (end) point on the master line.
The first swath to the left of the master line. (The direction "left" is relative to the direction the
master line was drawn, not the vehicle's current position).
The current swath and tag are orange.
Note: On a Pivot pattern, the swaths are numbered out from the center, not from the initial
swath.
The second line to the left of the master line.
Following Guidance
The lightbar displays guidance in two places:
On the LEDs•
On the screen•
Guidance on the LEDs
The term LED refers to the row of 15 Light Emitting Diodes (LEDs) that are located above the screen. The LEDs
that are lit up show the position of your vehicle relative to your intended guidance line. As your vehicle position
changes in relation to the guidance line, the lit LED moves left or right. Use the lightbar to obtain accurate
guidance, if an implement offset or implement draft is set, or for fine guidance on straight swaths.
VEHICLE POSITION LIGHTBAR APPEARANCE
Vehicle is directly on
the guidance line
The three center LEDs (green) show that the vehicle is online.
Vehicle is off the
guidance line
A single lit LED has moved right. This shows that the vehicle is offline to the left.
Note: This assumes that the LED Mode is set to Chase (the default). If the LED Mode
is set to Pull, the LEDs move left when the vehicle is offline to the left.
18
To Next Page
Loading...
Need help?
General
