Press to select the appropriate point feature icon.2.
ICON DESCRIPTION
Map a rock point feature
Map a weed point feature
Map a tree point feature
Map another generic point feature
Press . The point feature is mapped.3.
Note: By default, the point feature is mapped at the antenna location. To change where a feature is mapped, see
Recording Position .
Mapping line features
To map a line feature:
From mapping mode, select and press . The line feature mapping icon appears.1.
Press to select .2.
Press . The lightbar begins recording the line feature.3.
Drive the length of the line feature.4.
At the end of the line feature, check that is selected then press . The lightbar completes mapping
the line feature.
5.
72
To Next Page
Loading...