Trimble R1 - Legal Notices and Trademarks; Limited Warranty Terms and Conditions; Product Limited Warranty and Exclusions; Warranty Service and Limitations

LED information and power off
1. Charge battery
2
5 h
3. Bluetooth connection Power LED Turn off
Place the R1 GNSS receiver in pairing mode:
hold Power button for 5 seconds until
LED = - - -
?
2. Turn on
1.
2.
When LEDs =
,
release Power button.
After a few seconds,
LED = --- --- ---
1.
2.
Pair the receiver with your device:
PDF
Charging and operation
*On Android devices, enable Mock Locations. See the Trimble R1 GNSS
Receiver User Guide for more information.
•For Windows
®
7 and 8.x ,
Windows Embedded Handheld 6.5,
and Android* 4.1.x and later,
connect using Trimble field software,
or use the Trimble GNSS Status utility.
•For iOS, use Settings > Bluetooth
®
.
Hold Power button
LED =
LED =