Trimble R10 - OmniSTAR menu; OmniSTAR Summary

TrimbleR10ReceiverWebHelp
FrequencyRange–UsuallyoneofthefollowingMHzranges:410‐470,410‐430,430‐450,or450‐
470.
Tuningstep(kHz)–Thisvalueispresetdependentonthelocality/countrytheequipmentisbeing
usedin.ContactyourTrimbledealerifthisneedstobechanged.

MaximumNumberofChannels–Reportsthemaximumnumberoftransmitandreceive
frequenciespossiblefortheinternalradio.
CurrentNumberUsed–Displaysthenumberofreceiveonlyortransmit/receivefrequencies
alreadyinput.
FrequencyManagement–Addordeleteradiofrequencies.
{b}Note–{/b}Theabilitytoaddor
delete450MHzUHFradiofrequenciesisonlyapplicableto
Receivefrequencies.IfnewTransmitfrequenciesarerequired,pleasecontactyourTrimbledealer.
AddChannel–Enteravalidfrequencythatmeettherulesboundedbytheavailablefrequenciesfor
theradioandtheTuningstep.Whenavalidfrequencyis
added,thevalueinthe“CurrentNumber
used”fieldincrements.
DeleteChannel–Selectareceivefrequencyfromthelisttoremoveit.
GSM/GPRSmodem
Usethesesettingsto??
[Describethefields/optionsonthispage]
OmniSTARmenu
OmniSTARSummary
ThispageprovidesasummaryoftheOmniSTARinformation.
SignalSou rce–DisplaysthesourceoftheOmniSTARsignal,whichcaneitherbefromtheinternal
OmniSTARdemodulatororfromanexternalsourcethroughaserial,TCP/IP,orBluetoo thport.
SVName–DisplaysthenameoftheOmniSTARsatellitecurrently
beingtracked."Auto"indicates
thatthesatellitewasselectedbasedongeographicallocation.
Frequency(MHz)–DisplaysthefrequencythattheOmniSTARsatellitethatiscurrentlytrackedis
broadcastingon.
BitRate(Hz)–DisplaytherateatwhichthetrackedOmniSTARdataismodulatedtothecarrier
wave.
Setting–IndicatesifthereceiverissettotrackOmniSTARsatellites.
Mode–IndicatesiftheinternaldemodulatoriscurrentlytrackinganOmniSTARsatellite,orif
externalOmniSTARdataisbeingreceivedfromanothersource.
C/No[dBHz]–Displaysthesignal‐to‐noiseratioina1Hzbandwidthofthe
signalbeingtracked.
SNR(Eb/No)–Displaysthesignal‐to‐noiseratioofthesignalbeingtracked.
TotalMessages–DisplaysthetotalnumberofmessagesreceivedfromtheOmniSTARsatellite.