Trimble R10 - OmniSTAR Configuration

TrimbleR10ReceiverWebHelp
BadMessages–DisplaysthenumberofOmniSTARmessagesthatthereceiverhasdistinguishedas
notusable.
TotalUniqueWordBits–Thetotalnumberofbitsinuniquewordsyouhavereceived.Trimble
SupportcanusethistotroubleshootOmniSTARtrackingproblems.
BadUniqueWordBits
–Thetotalnumberoferrorbitsdetectedinuniquewords.TrimbleSupport
canusethistotroubleshootOmniSTARtrackingproblems.
TotalViterbisymbols–ThetotalnumberofViterbi‐encodedsymbolsyouhavereceived.Trimble
SupportcanusethistotroubleshootOmniSTARtr ackingproblems.
CorrectedViterbisymbols–The
totalnumberofViterbi‐encodedsymbolsthatwereautomatically
correctedbythedecodingalgorithm.TrimbleSupportcanusethistotroubleshootOmniSTAR
trackingproblems.
EstimatedBER–EstimatedBitErrorRate.
I/QRatio–Theratioofin‐phasetoquadraturecarriertrackingloopsignalstrength.Trimble
Supportcanusethis
totroubleshootOmniSTARtrackingproblems.
UniqueWordswithBiterrors–Thetotalnumberofreceiveduniquewo rdswithatleasta1‐bit
error.TrimbleSupportcanusethistotroubleshootOmniSTARtrackingproblems.
OmniSTARConfiguration
UsethispagetoconfigurethereceivertotrackOmniSTARsatellites.
{b}Note–{/b}TheremustbeavalidOmniSTARsubscriptiononthereceiverbeforeitcanuse
internalorexternalOmniSTARdataforpositioning.
PreferredSourceofData–SelecteitherExternalorInternal.Ifthereceiverisconfiguredbelow
to
usebothinternalandexternalOmniSTARdata,itusesthepreferredsourcewhenbothare
available:
 Internal–TheOmniSTARdataisderivedfromtheL‐Bandsignalreceivedviaanappropriate
antenna(e.g.,GA810).
 External–TheOmniSTARdataisderivedfromanexternalsourcesuch
asanNTRIPClientover
anInternetconnection.
ExternalOmniSTARData–SetthereceivertouseanexternalOmniSTARdatastreamifavailable
onanEthernet,NTRIP,serial,Bluetooth,orUSBportandthenuseoneofthefollowingmodes:
 Don’tUse–Donotuseanexternalsource
ofOmniSTARdata.
 Auto–Trackingisenabledand,ifmorethanoneexternalOmniSTARserviceisavailable,the
mostprecisemodeisused.
 Selectingspecificservices–Thefollowingspecificservicesareavailableforselectionifthe
receiverhasanappropriatevalidsubscription.Selectingoneofthese
modesrestrictsthe
receiverfromusingotherexternalOmniSTARservices:
 HPOnly
 G2Only
 HP+G2