Trimble R10 - Page 48

TrimbleR10ReceiverWebHelp
TheBluetoothpairingandhardwaresetuparenowcomplete.
Section3‐CreatinganInternetconnection
1. IntheControlPanel,clicktheViewnetworkstatusandtaskslink:

Thefollowingscreenappears:

2. ClicktheSetupanewconnectionornetworklink.Thefollowing
screenappears:

3. SelectSetupadial‐upconnectionandthenclickNext:

4. TheCommunicationscablebetweentwocomputersmodemyoucreatedinSection2shouldbe
visible.Clickonittocontinue.Thefollowingscreenappears:

5. IntheDial‐upphonenumberfield,enter1.
Thisisaplaceholdernumberthatyouwilldelete
later.afteryou enterityouwillbeabletoclickConnect.AfteryouclickConnect,thefollowing
screenappears:

6. Windows7attemptstoconnecttotheInternetusingtheconnection.Asitisnotyet
configuredthiswill
notwork.ClickSkiptocontinue.Thefollowingscreenappears:

7. ReturntotheNetworkandSharingCenterintheControlPanel.ClicktheConnecttoanetwork
link.Thefollowingscreenappears:

8. Right‐clicktheDial‐upConnectionlinkandthenfromtheshortcutmenuthatappears
select
Properties.Thefollowingdialogappears:

9. InthePhonenumberfield,removetheplaceholder"1"andthenclickOK.Thefollowingscreen
appears:

10. ClicktheConnecttoanetworklinkagain(seeStep7),right‐clicktheDial‐upconnectionand
fromtheshortcutmenuthat
appears,selectConnect:

11. ClickDial.
12. Nexttoyourdial‐upconnection,clickontheblueDial‐upConnectionlink.Thefollowingscreen
appears:
