Trimble R10 User Manual

TrimbleR10ReceiverWebHelp
–Donotdroporpuncturethebattery.
–Donotopenthebatteryorshort‐circuititscontacts.
WARNING–AvoidcontactwiththerechargeableLithium‐ionbatteryifitappearstobe
leaking.Batteryfluidiscorrosive,andcontactwithitcanresultinpersonal
injuryand/or
propertydamage.
Topreventinjuryordamage:
–Ifthebatteryleaks,avoidcontactwiththebatteryfluid.
–Ifbatteryfluidgetsintoyoureyes,immediatelyrinseyoureyeswithcleanwaterand
seekmedicalattention.Donotrubyoureyes!
–Ifbatteryfluidgetsonto
yourskinorclothing,immediatelyusecleanwatertowashoff
thebatteryfluid.
Connectingthereceivertoavehiclebattery
WARNING–Usecautionwhenconnectingbatterycable'sclipleadstoavehiclebattery.Do
notallowanymetalobjectorjewelrytoconnect(short)thebattery'spositive(+)terminal
toeitherthenegative(‐)terminalorthemetalofthevehicleconnectedtothebattery.This
couldresultinhighcurrent,arcing,andhightemperatures,exposingtheusertopossible
injury.
WARNING–When
connectinganexternalbattery,suchasavehiclebattery,tothe
receiver,besuretousetheTrimblecablewithproperover‐currentprotectionintendedfor
thispurpose,toavoidasafetyhazardtotheuserordamagetotheproduct.
ChargingtheLithium‐ionbattery
TherechargeableLithium‐ionbatteryissuppliedpartiallycharged.Chargethebatterycompletely
beforeusingitforthefirsttime.Ifthebatteryhasbeenstoredforlongerthanthreemonths,
chargeitbeforeuse.
WARNINGChargeandusetherechargeableLithium‐ionbatteryonlyin
strictaccordance
withtheinstructions.Chargingorusingthebatteryinunauthorizedequipmentcancause
anexplosionorfire,andcanresultinpersonalinjuryand/orequipmentdamage.
Topreventinjuryordamage:
–Donotchargeorusethebatteryifitappearstobedamagedorleaking.
–ChargetheLithium
‐ionbatteryonlyinaTrimbleproductthatisspecifiedtochargeit.Be
suretofollowallinstructionsthatareprovidedwiththebatterycharger.
–Discontinuechargingabatterythatgivesoffextremeheatoraburningodor.
–UsethebatteryonlyinTrimbleequipmentthatis
specifiedtouseit.
–Usethebatteryonlyforitsintendeduseandaccordingtotheinstructionsintheproduct
documentation.
Tochargethebattery,firstremovethebatteryfromthereceiver,andthenplaceitinthebattery
charger,whichisconnectedtomainspower.

Trimble R10 Specifications

General

Channels	440
RTK Horizontal Accuracy	8 mm + 1 ppm RMS
RTK Vertical Accuracy	15 mm + 1 ppm RMS
Operating Temperature	-40 °C to +65 °C
L1 C/A Code	Yes
L2E	Yes
L2C	Yes
L5	Yes
Beacon	No
FM Radio	No
WAAS	Yes
MSAS	Yes
EGNOS	Yes
Storage Temperature	-40 °C to +75 °C
Ingress Protection	IP67
Positioning Accuracy (Static) - Horizontal	3 mm + 0.5 ppm RMS
Positioning Accuracy (Static) - Vertical	5 mm + 0.5 ppm RMS
Signal Tracking	BeiDou
RTK Initialization	< 8 seconds
Battery Life	Up to 7 hours
SBAS Accuracy	50 cm
Glonass Code	L1 C/A, L2 C/A
Communications	Bluetooth