Trimble R10 - Reference Station

TrimbleR10ReceiverWebHelp
AntennaType–Selectthetypeofantennabeingusedwiththereceiver.
AntennaSerialNumber–Entertheserialnumberoftheantennabeingused.
AntennaMeasurementMethod–Selecthowtheantennaheightisbeingmeasured.
AntennaHeight[m]–Enterthemeasuredheightof
theantenna.Thisistypicallymeasuredfroma
groundmarkerorthemountingpointoftheantenna.
{b}Note–{/b}Ifavailable,animageoftheselectedantennaisdisplayed,sothatyoucanconfirm
thatyouhaveselectedthecorrectantenna.
AntennaConfiguration
Usethesesettingstodefinetheantennabeingusedbythereceiver.
AntennaType–Selectthetypeofantennabeingusedwiththereceiver.
AntennaSerialNumber–Entertheserialnumberoftheantennabeingused.
AntennaMeasurementMethod–Selecthowtheantennaheightisbeingmeasured.
Antenna
Height[m]–Enterthemeasuredheightoftheantenna.Thisistypicallymeasuredfroma
groundmarkerorthemountingpointoftheantenna.
{b}Note–{/b}Ifavailable,animageoftheselectedantennaisdisplayed,sothatyoucanconfirm
thatyouhaveselectedthecorrectantenna.
ReferenceS tation
UsethesesettingstosetthepositionofthereceiverandtheIDofthedataforuseinRTCMand
CMRoutput.
SelectReceiverConfiguration/ReferenceStation.
CMRID–EnterastationIDforCMRcorrectionsgeneratedbythereceiver(0through31).
RTCM2.xID–
EnterastationIDforRTCM2.xcorrectionsgeneratedbythereceiver(0through
1023).
RTCM3.xID–EnterastationIDforRTCM3correctionsgeneratedbytherece iver(0through
4095).
StationName–Enteranameforthereferencestation(upto16characters).
StationCode –
Enteradescriptionforthereferencestation(upto16characters).
ReferenceLatitude–Enterthelatitudeofthereferencestationindegrees,minutes,seconds,and
northorsouthhemisphere.EnteraWGS‐84positiononly.
ReferenceLongitude–Enterthelongitudeofthereferencestationindegrees,minutes,seconds,
andeastorwesthemisphere.EnteraWGS‐84positiononly.
ReferenceHeight–Entertheellipsoidalheightofthereferencestationinmeters.EnteraWGS‐84
heightonly.TheAntennaPhaseCentermustbedirectlyverticallyabovethestation.
Here–Clicktoloadthecurrentpositionofthe
receiverasthereferencestationposition.
{b}Note–{/b}TheabovesettingsarenotapplieduntilyouclickOK.