Trimble TSC3 User Manual

8
8. Language selection
The first time the unit is turned on or if the firmware is re-loaded,
you may need to select the desired language.
1. Use the up or down arrows to highlight the language desired
and press Enter to select it. (The touchscreen is not enabled
yet).
2. Use the up or down arrows to highlight the checkbox.
3. Press Enter to place a checkmark in the box for “Yes”.
4. Use the up or down arrows to highlight NEXT and press
Enter.
5. Wait while your unit is being configured to the chosen
language. It will restart when finished.
IMPORTANT: Carefully choose the correct language as all
other languages are removed after this selection. Contact
technical support if the wrong language was selected.
UP
DOWN
ENTER
NEXT

Trimble TSC3 Specifications

General

Operating System	Windows Embedded Handheld 6.5
Memory	256 MB RAM
Processor	Texas Instruments DM3730
Connectivity	Bluetooth, Wi-Fi
Camera	5 MP camera with autofocus and flash
GPS	Integrated GPS receiver
Ports	USB
Ruggedness	IP67
Battery	Rechargeable Li-ion battery