Trinity 100 QT - Step 5: Install Drain Plug; Step 6: Set Lid

© 2017 TRINITY - 800.985.5506
4
Set LID (B) on top of TUB (A).
Clean the inside of the Cooler thoroughly
before use.
Unscrew the DRAIN PLUG (J) assembly. Insert
the DRAIN PLUG (J) through the opening in
the TUB (A) from the inside. Make sure the
rubber seal is on the inside of the TUB (A).
From the outside, slide the washer on first,
then the second washer with the chain
attached, and then screw on the nut. Be sure
not to overtighten. Once the DRAIN PLUG (J)
is in place, screw on the cap.
STEP 5
STEP 6
ASSEMBLY INSTRUCTIONS
J (1)
J
B
Inside the tub
Outside the tub
B (1)