INSTALLATION INSTRUCTIONS – On Wire Rack
STEP 1
Identify LEFT & RIGHT SLIDES (B) & (C).
Place SLIDES (B) & (C) on desired wire shelf. Make sure FRONT of SLIDES (B) & (C)
is lined up with FRONT of shelf.
Line up slides along wires in wire shelf to ensure they are straight. Make sure
front edge of WIRE DRAWER (A) lines up to edge of shelf so they are flush.
Note: BACK end of each SLIDE (B) & (C) has a clear tip and FRONT
end does NOT.
CLIPS should be on the
OUTSIDE.
BACK
FRONT
STEP 2
Rest LOWER DRAWER (A) on top of the CLIPS to ensure proper SLIDE spacing.
Position as such:
Note: For ease of installation,, do NOT clip LOWER DRAWER (A)
into LEFT & RIGHT SLIDES (B) & (C) until Step 4.
© 2023 TRINITY - 800.985.5506
4
To Next Page
Loading...
