Need help?Do you have a question about the Trio CS-1560AII and is the answer not in the manual?
General| Brand | Trio |
|---|---|
| Model | CS-1560AII |
| Category | Test Equipment |
| Language | English |
Details on the oscilloscope's cathode ray tube type, accelerating voltage, and scale.
Technical specifications for the vertical amplifier channels, including input impedance and frequency response.
Specifications for the common sweep circuit, covering system, time, and magnification.
Specifications related to the triggering system, including source, slope, and voltage.
Specifications for the horizontal amplifier, including X-Y operation and deflection factor.
Details on power requirements, dimensions, weight, and accessories.
Detailed description and layout of controls located on the front panel of the oscilloscope.
Description and layout of controls and connectors found on the rear panel of the oscilloscope.
Step-by-step instructions for operating the oscilloscope and performing measurements.
Explains the use of dual-trace functionality for simultaneous waveform viewing and analysis.
Method for measuring distortion in amplifiers using square wave and dual-trace capabilities.
Using dual-trace to determine delay times and pulse distortion in delay lines.
Procedure for testing a burst circuit, analyzing waveforms using dual-trace.
Application of the oscilloscope for troubleshooting stereo amplifiers.
Technique to minimize unwanted signal components using the oscilloscope's SUB mode.
Measuring phase shift in amplifiers using sine wave input and dual-trace.
Using the oscilloscope for servicing television receivers, including VITS signal analysis.
Utilizing the oscilloscope for television servicing tasks with single-channel operation.
Analyzing composite video signals for troubleshooting in TV receivers.
Evaluating IF response by analyzing sync pulse waveform distortions.
Performing phase measurements using Lissajous patterns generated by X-Y mode.
Measuring unknown frequencies by comparing Lissajous patterns with a known frequency.
Procedures for the general maintenance and upkeep of the oscilloscope unit.
Steps involved in safely removing the outer case for internal access.
Instructions for performing various calibration and adjustment procedures on the unit.
Procedures for adjusting power supply voltages and CRT circuit parameters.
Steps for calibrating the vertical amplifier and associated controls.
Procedures for adjusting the horizontal positioning and sweep controls.
To Next Page
