Vacuum Tube Integrated Amplifier
㓺䞒䄺G㡆ἆGSpeaker Connection
Banana plug
Spade plug or Bare Wire
㓺䞒䄺㦮G㧚䞒▮㓺⯒G䢫㧎䞮ἶSGRGTG⁏㎇㦚Gⰴ㿪㠊G㡆ἆ䞮㕃㔲㡺U 앰프의 0단자는 - 입니다. G
Check the impedance of speakers. Attach the positive from your speaker to the 6 or 8 ohm terminals and the negative to the 0 ohm terminals.
]¥_㢊G㓺䞒䄺ṖG⧢㰗䞿┞┺UG[㢊㓺䞒䄺⓪G]㢊┾㧦㠦G㡆ἆ䞮㕃㔲㡺UG
6~8ohm speakers are preferential.
If your speakers are 4 ohm, it would not cause damage to the amplifier. You can attach them to the 6 ohm terminals.
Ho
w to connect the speaker cables:
1. Unscrew the terminal knobs.
2. Insert the speaker cables.
3. Screw the terminal knobs.
Note:
주의:
• 사고 방지를 위해 스피커 케이블을 연결한 다음에 전원코드를 연결하십시오.
• 㓺䞒䄺G㴓G┾㧦㠦G䅖㧊な㦚GⲒ㩖G㡆ἆ䞮ἶG⋲G⛺㠦G㟆䝚㴓G㿲⩻G┾㧦㠦G㡆ἆ䞮㕃㔲㡺U
Connect the speaker cables with the amplifier after it is well connected with the speakers.
• 㓺䞒䄺G䅖㧊な㠦G䚲㔲♲G䢪㌊䚲G䟻㦚G䢫㧎䞮㡂G㡆ἆ䞮㕃㔲㡺U
• 㟆䝚㢖G㓺䞒䄺G┾㧦㦮GRGT⁏㎇㦚Gⰴ㿪㕃㔲㡺U
(앰프의 스피커의 극성이 엇갈리지 않도록 주의하십시오. )
• 앰프의 0단자는 스피커의 -와 연결하십시오.
black (-)
red (+)
black (-)
red (+)
MODE L TR V-A 300XR
PS
E
100 V~ 1 20W 50/60Hz
To Next Page
Loading...
