Triple S Ultron 20TD - User Manual

Questions and Answers

C
Christopher HaynesAug 10, 2025
What to do if my Triple S Ultron 20TD has poor water pick up?
- W
  wheelertracyAug 10, 2025
  If the Triple S Ultrasonic Jewelry Cleaner isn't picking up water effectively, it might be due to several reasons. First, check if the recovery tank is full and needs draining. Ensure the drain hose cap is tightened. Inspect the float shut-off screen in the recovery tank and the squeegee assembly for clogs, cleaning them if necessary. Examine the squeegee blades for wear and replace or rotate them as needed. Adjust the squeegee blade height if the deflection is incorrect. Secure any loose vacuum hose connections and clear any blockages in the vacuum hose. If the vacuum hose is damaged, replace it. Make sure the recovery tank cover is properly positioned and that the seal isn't damaged; replace the seal if needed. Also, check the battery charge level and recharge if low.
A
Andrew MendozaAug 16, 2025
Why won't my Triple S Ultron 20TD Ultrasonic Jewelry Cleaner operate?
- J
  Jacqueline KeithAug 16, 2025
  If your Triple S Ultrasonic Jewelry Cleaner machine won't operate, there are several potential causes. Ensure the control handle bail is fully pulled. Check the batteries; they may need charging or replacing. Also, verify the battery connections are secure and tightened. Inspect the main control unit for a tripped circuit breaker and reset it if necessary.
M
Michelle HaynesAug 25, 2025
How to fix little or no solution flow in my Triple S Ultron 20TD Ultrasonic Jewelry Cleaner?
- M
  Mrs. Tina JonesAug 25, 2025
  If you're experiencing little to no solution flow in your Triple S Ultrasonic Jewelry Cleaner, start by checking the ball valve to ensure it's fully open. Next, verify that the solution flow control knob is properly adjusted and not set too low or shut off. Inspect the solution tank filter and solution hose for any clogs, cleaning or flushing them as needed. Lastly, check the solution solenoid valve for clogs and clean it if necessary.
M
Melissa Kennedy PhDSep 1, 2025
Why does my Triple S Ultron 20TD have a short run time?
- J
  John HudsonSep 1, 2025
  If your Triple S Ultrasonic Jewelry Cleaner has a short run time, the issue could stem from a few sources. Begin by fully recharging the batteries. If the problem persists, the batteries might be defective and need replacing. Additionally, inspect the battery charger for any faults, repairing or replacing it as necessary. Check the down pressure lever and lower it if it's set for extra scrub head pressure.

Summary

SAFETY PRECAUTIONS

OPERATING AND SERVICING SAFETY

Essential safety rules for operating and servicing the machine.

MACHINE COMPONENTS

PANEL COMPONENTS

MACHINE SETUP AND INSTALLATION

MACHINE OPERATION

OPERATING THE MACHINE

Step-by-step guide for operating the machine.

MAINTENANCE AND CHARGING

BATTERY CHARGING GUIDELINES

Instructions for charging the machine's batteries safely.

DAILY MAINTENANCE

MONTHLY MAINTENANCE

BATTERY MAINTENANCE

FAULT CODE AND SOLUTION

BASIC TROUBLESHOOTING

WIRING DIAGRAM (Ultron 20 BA)

WIRING DIAGRAM (Ultron 20 TD & Ultron 20 TO)

Triple S Ultron 20TD Specifications

General

Model	Triple S Ultron 20TD
Category	Ultrasonic Jewelry Cleaner
Frequency	40 kHz
Power	50 W
Heating Function	Yes
Weight	1.5 kg
Timer	1-30 minutes
Power Supply	AC 220-240V, 50Hz