Triplett MM200 - Safety; General Safety Precautions; Safety Standards

Safety
This symbol, adjacent to another symbol or terminal, indicates the user must
refer to the manual for further information.
This symbol, adjacent to a terminal, indicates that, under normal use,
hazardous voltages may be present
Double insulation
• Improper use of this meter can cause damage, shock, injury or death. Read and understand
this user manual before operating the meter.
• Make sure any covers or battery doors are properly closed and secured.
• Always remove the test leads before replacing the battery or fuses.
• Inspect the condition of the test leads and the meter itself for any damage before
operating the meter. Repair any damage before use.
• Do not exceed the maximum rated input limits.
• Use great care when making measurements if the voltages are greater than 25VAC
rms or 35VDC. These voltages are considered a shock hazard.
• Always discharge capacitors and remove power from the device under test before
performing Diode, Resistance or Continuity tests.
• Remove the battery from the meter if the meter is to be stored for long periods.
• To avoid electric shock, do not measure AC current on any circuit whose voltage
exceeds 250V AC.
Safety standards
Design standards
EN61010-1: 2010; EN61010-2-030:2010; EN 61326-1:2013
EN61010-2-033:2012,EN61326-2-2:2013
EMC
RF field (1V/m): Overall accuracy = specified accuracy ± 5% of range
RF field (>1V/m): No specified calculation
Measurement
standards
CAT III 600V, double insulation and material pollution degree II
Dimensions
130mm×65mm×28mm
Weight
About 130g (including batteries)