Need help?Do you have a question about the Triplett TVR1G and is the answer not in the manual?
General| Category | Test Equipment |
|---|---|
| Model | TVR1G |
| Manufacturer | Triplett |
| Type | Cable Tester |
| Continuity Test | Yes |
| Display | LED |
| Power Source | 9V Battery |
| Cable Types | Coaxial |
| Impedance | 75 ohm |
Read and follow safety rules, avoid low battery operation, check cable types, and handle damaged testers with care.
Explains symbols indicating potential danger, hazardous voltages, and double insulation for user safety.
Identifies and describes the main unit and probe components of the TVR1G LAN Network Tester.
Details how to verify the network speed (10/100/1000 MB/s) and duplex type (half/full) of connected devices.
Instructions for performing a single port test to check device connectivity and transmission on specific pins.
Guide to testing network negotiation between two devices connected inline via the tester.
Procedures for testing Power over Ethernet (PoE) sources, distinguishing between endspan and midspan.
Methods for testing cable continuity, wiring, and tracing cables using the tester and remote probe.
Explains how the tester signals low battery conditions and the impact on its functionality.
Lists technical parameters such as LAN speed, duplex types, voltage, battery, and operating environment.
Outlines the warranty terms, duration, and conditions for the Triplett TVR1G tester.
To Next Page
