15
FIG.11FIG.10
BEFORE YOU BEGIN
Before using the TriPollar STOP V device, do the following:
1.
Open the box containing the device, and remove the device and its power supply.
2. Insert the adapter onto the electrical posts (Fig.10).
3. Twist the adapter clockwise to secure it (Fig.11).
4. Connect the power supply to the device (Fig.12).
5. Plug the power supply into an electrical outlet (Fig.13).
6. Remove the STOP Preparation Gel from its box.
Important: Before using the device for the first time, it is recommended
to perform a patch test 24 hours prior to initial use. To do so, apply a
small amount of STOP Preparation Gel to the inner arm and treat the
area with the TriPollar STOP V device. Ensure that the skin does not have
a negative reaction to the gel or treatment.
7. Remove the protective cover from the device.
To Next Page
Loading...