19
For effective treatment, the goal is to maintain the optimal temperature
for several seconds before moving to the next treatment section. This
means that the orange indicator light should be illuminated as much as
possible when treating an area.
Important: The orange indicator light turns ON and OFF, depending on
the temperature of the skin in the current area of treatment. The orange
light is ON when the temperature of the skin in that area is sufficiently
heated and is OFF when it is not. In addition, a beep sounds whenever
the orange indicator light turns ON.
For optimal treatment, it is recommended to begin the treatment using
the Low power setting in RF mode and to follow the guidelines below:
• If the orange indicator light and sound indicators do not appear within
5 minutes, or if you do not feel any heating, try moving the device as
slowly as possible without stopping the motion. Slow, circular, constant
movements are more effective than rapid movements. The slower the
movement, the faster the treatment area heats internally.
•
If the orange indicator light and sound indicators still do not appear after
3-5 minutes, select a higher power level. If the indicators still do not
appear after increasing to the High power setting, try moving the device
more slowly, without stopping the motion.
• If the orange indicator light and sound indicators turn ON immediately
or if you feel excessive heat, select a lower power level.
9. Repeat this technique one working section at a time until the entire
treatment area has been heated.
10. For best results, after treating all working sections on one side of your
To Next Page
Loading...