7
Operation
Bind KVM and USB
Hub Functionality
[Scroll Lock] [Scroll Lock] [Z] When the KVM and USB Hub
functionality have been unbinded,
performing this hotkey command will
bind them back together. The focus of
the USB Hub ports, KVM and Audio
will now all switch at the same time.
The KVM and USB Hub functionality
are binded together by default.
Select the Previously
Selected Computer
Port
[Scroll Lock] [Scroll Lock]
[Backspace]
Switches the focus of the KVM,
Audio, and USB Hub ports to the last
computer port that was accessed prior
to your current port.
Select the Next
Higher Accessible
Port
[Scroll Lock] [Scroll Lock] [↑] Switches the focus of the KVM, Audio,
and USB Hub ports to the next higher
accessible port in the installation.
(e.g. 1 to 2, 2 to 3, etc.) This hotkey
command only switches to accessible
ports and will not switch to an empty
port.
Select the Next
Lower Accessible
Port
[Scroll Lock] [Scroll Lock] [↓] Switches the focus of the KVM, Audio,
and USB Hub ports to the next lower
accessible port in the installation.
(e.g., 3 to 2, 2 to 1, etc.) This hotkey
command only switches to accessible
ports, and will not switch to an empty
port.
Turn Beep Sound
On/Off
[Scroll Lock] [Scroll Lock] [B] Toggles the Beep sound on and off.
The Beep sound is turned on by
default.
Auto Scan [Scroll Lock] [Scroll Lock] [S] [x]
x = 1 – 9
Activates an Auto Scan at a time
interval from 10 to 90 seconds.
(e.g. 1 = 10 seconds, 2 = 20
seconds, etc.) Press any key during
an Auto Scan to stop it at the
currently selected port. Auto Scan
only switches between accessible
ports, and will not switch to an empty
port.
17-10-495 93-3345.indd 7 12/5/2017 9:41:26 AM
To Next Page
Loading...
Need help?
General
