Tripp Lite B126-1A1-WP User Manual

14
Standard Extender/Splitter Installation
1
Make sure the HDMI source is powered OFF.
2
ConnecttheHDMIsourcetotheINPUTportontheB126-002or
B126-004usingaTrippLiteP568-SeriesHDMICable.
3
Optional for B126-004: Connect an HDMI monitor to the LOCAL
portontheB126-004usingaTrippLiteP568-SeriesHDMICable.
4
Connect the external power supply to the B126-002 or B126-004
local unit and plug it into a Tripp Lite Surge Suppressor, PDU or UPS.
ThegreenRJ45LEDsandtheredPowerLEDontheB126-004,and
thegreenRJ45LEDsontheB126-002,willilluminatetoindicate
power is being received from the external power supply.
5
UsingCat5e/6cable,connectoneoftheRJ45outputportsonthe
localunittotheRJ45inputportonaB126-1P0,B126-1A0,
B126-1P0-WP-1 or B126-1A0-WP-1 remote unit.
6
Repeatstep5foreachadditionalremoteunityouareconnecting.
7
B126-1A0 and B126-1A0-WP-1 only: Connect the external power
supply to the B126-1A0 or B126-1A0-WP-1, and plug it into a
Tripp Lite Surge Suppressor, PDU or UPS. The green and orange
LEDs illuminate, with the green LED indicating the unit is receiving
power from the external power supply, and the orange LED indicating
theunitisconnectedtoapoweredONlocalunitviaCat5e/6cable.
8
Repeatstep7foreachadditionalB126-1A0orB126-1A0-WP-1in
the installation.
9
ConnecttheB126-1P0HDMIconnectortoamonitor;or,connect
the B126-1P0-WP-1, B126-1A0 or B126-1A0-WP-1 to a monitor
usingaTrippLiteP568-SeriesHDMICable.Boththegreenand
orangeRJ45LEDsontheB126-1P0,andthegreenLEDonthe
B126-1P0-WP-1, illuminate to indicate the unit is receiving power
from the connected monitor.
201109206-93-3023-EN.indd 14 10/24/2011 10:01:21 AM

Tripp Lite B126-1A1-WP Specifications

General

Brand	Tripp Lite
Model	B126-1A1-WP
Category	Extender
Language	English