Tripp Lite B126-1A1-WP User Manual

21
Extender/Splitter Daisy-Chain Installation (B126-004 only)
1
Make sure the HDMI source is powered OFF.
2
ConnecttheHDMIsourcetotheINPUTportontheB126-004using
aTrippLiteP568-SeriesHDMICable.
3
ConnecttheLOCALportontheB126-004totheINPUTportona
second B126-004 using the included 1-ft. HDMI daisy-chain cable.
4
Repeatstep3ifyouwanttoconnectathirdB126-004.
5
Optional: Connect a local monitor to the LOCAL HDMI port of the
lastB126-004usingaTrippLiteP568-seriesHDMIcable.
6
ConnecttheexternalpowersupplytotherstB126-004inthe
daisy-chain and plug it into a Tripp Lite Surge Suppressor, PDU or
UPS.ThegreenRJ45LEDsandtheredPowerLEDontheB126-
004 will illuminate to indicate power is being received from the
external power supply.
7
Repeat step 6 for each additional B126-004 in the daisy-chain.
8
UsingCat5e/6cable,connectoneoftheRJ45outputportsonthe
localunittotheRJ45inputportonaB126-1P0,B126-1A0,
B126-1P0-WP-1 or B126-1A0-WP-1 remote unit.
9
Repeatstep8foreachadditionalremoteunityouareconnecting.
10
B126-1A0 and B126-1A0-WP-1 only: Connect the external power
supply to the B126-1A0 or B126-1A0-WP-1, and plug it into a Tripp
Lite Surge Suppressor, PDU or UPS. The green and orange LEDs
illuminate, with the green LED indicating the unit is receiving power
from the external power supply, and the orange LED indicating the
unitisconnectedtoapoweredONlocalunitviaCat5e/6cable.
11
Repeat step 10 for each additional B126-1A0 or B126-1A0-WP-1 in
the installation.
201109206-93-3023-EN.indd 21 10/24/2011 10:01:23 AM

Tripp Lite B126-1A1-WP Specifications

General

Brand	Tripp Lite
Model	B126-1A1-WP
Category	Extender
Language	English