5
Standard Installation
5
Using Cat5e/6 cable, connect RJ45 port 1A to a B140-Series remote
receiver unit.
6
Repeat step 5 to connect each RJ45 port to a B140-Series remote
receiver unit.
7
B140-1A0 and B140-1A0-WP only: Connect the external power supply
to the active receiver unit, and plug it into a Tripp Lite Surge Suppressor,
PDU, or UPS. When receiving power, the Green RJ45 LED on the
B140-1A0, and the Green Power LED on the B140-1A0-WP, will illuminate.
8
Repeat step 7 for each active receiver unit in the installation.
9
Connect a receiver unit to a monitor using a Tripp Lite P561-Series
DVI-D Single-Link cable. If you have a B140-1P0, connect its built-in DVI
connector to a monitor. When connected to and receiving power from a
monitor, the Green RJ45 LED on the B140-1P0, and the Green Power LED
on the B140-1P0-WP, will illuminate.
Note: See note number 3 at the beginning of the Standard Installation section, and
reference the installation diagram, to ensure that the correct video signals are transmitted to
the monitors in your Dual Display installations.
10
Repeat step 9 to connect each receiver unit to a monitor.
11
Turn on the power to the DVI source. The Orange RJ45 LEDs on the
B140-002-DD and B140-1A0, and the Orange Activity LED on the
B140-1A0-WP, will illuminate. The video image should now be displayed
on the connected monitors.
12
B140-1A0 and B140-1A0-WP only: If necessary, use the Equalization
control to adjust the video image.
Note: An improper Equalization setting can cause the monitor not to display an image at all.
Try each setting until an acceptable image is displayed.
13-01-085-933287_revA.indd 5 1/30/2013 3:44:18 PM
To Next Page
Loading...
