To Next PageTo Next Page
Need help?Do you have a question about the Tripp Lite Cat6 and is the answer not in the manual?
Remove approximately 30 mm of cable sheath to prepare for termination.
Release the wire cap, pass the cable through it, and align wires to color positions.
Ensure the wire cap aligns with the jack's latch tab and lock it in place.
Use a flathead screwdriver to unlock the keystone jack for disconnection.
Remove approximately 30 mm of cable sheath to prepare for termination.
Release the wire cap, pass the cable through it, and align wires to color positions.
Ensure the wire cap aligns with the jack's latch tab and lock it in place.
Use a flathead screwdriver to unlock the keystone jack for disconnection.
General| Brand | Tripp Lite |
|---|---|
| Model | Cat6 |
| Category | Jacks |
| Language | English |
