Tripp Lite SRCOOLNET - Page 8

8
Installation
DO NOT MODIFY UNLESS DIRECTED BY YOUR ADMINISTRATOR
Do you want to completely erase the file system? [N]
DO NOT MODIFY UNLESS DIRECTED BY TRIPP LITE TECHNICAL SUPPORT
Default Ethernet setting (0=Auto, 1=10 Half, 2=10 Full, 3=100 Half, 4=100
Full)? [Auto]
DO NOT MODIFY UNLESS DIRECTED BY YOUR ADMINISTRATOR
Youcanalsochangetherootpassword,real-timeclockandothersettings.
Tripp Lite recommends against changing the default settings unless you are an
advanceduserwithaspecificpurpose.Afteryouhavefinishedenteringsettings,
theSRCOOLNETwillsavechangestomemoryandreboot(thismaytakeseveral
minutes).AftertheSRCOOLNETreboots,theinitializationpageshoulddisplaythe
newstaticIPsettings.
3-8
Remove Configuration Cable: Remove the configuration cable that connects
the SRCOOLNET to the computer.
4 - Test and Configure
4-1
Test Network Connection: AfteranIPaddresshasbeenassignedtothe
SRCOOLNET, try to access it with a Web browser that supports frames, forms
andJava™.OpenaWebbrowseronacomputerconnectedtotheLANandenter
theSRCOOLNET’sIPaddress.Youwillbepromptedforapassword.Theuser
nameislocaladminandthedefaultpasswordislocaladmin.Afteryouenterthe
usernameandpassword,thePowerAlertStatuspagewillappearinthebrowser
window. For more information about configuration and operation of the managed
device,refertotheUser'sGuide,includedontheCD-ROMbundledwiththe
SRCOOLNET.
Note: When using the SRCOOLNET with the SRCOOL12K or SRXCOOL12K, do
not use the cooling unit’s manual control panel.
13-08-187 93-32CA.indb 8 9/27/2013 9:25:21 AM