Tripp Lite SRCOOLNET - SNMP Settings; Ftp; Remote View Access Port

To Next Page

To Previous Page

4. Telnet/SSH Console continued

4.3 Network Conﬁguration continued

4.3.3.3 SNMP Settings

This menu allows the user to conﬁgure SNMP set and get settings.

Menu Data

Automatically Start SNMP

This menu asks if when the card is started, the SNMP application

should be started as well. Valid Values:

• Yes

Start the application.

• No

Do not start the application.

SNMP Port

If the application is to be started, then this is the port to use for SNMP

set and get requests.

Enable SNMP V1

This indicates if SNMPv1 should be enabled on card startup.

Enable SNMP V2c

This indicates if SNMPV2c should be enabled on card startup.

Enable SNMP V3

This indicates if SNMPV3 should be enabled on card startup.

Note: The SNMP enable ﬂags will not change the default local users

created.

4.3.3.4 FTP

This menu allows the user to conﬁgure the FTP client settings.

Menu Data

Automatically Start FTP

This menu asks if when the card is started, the FTP application should

be started as well. Valid Values:

• Yes

Start the application.

• No

Do not start the application.

FTP Port

If the application is to be started, then this is the port to use for FTP

transfers.

4.3.3.5 Remote View Access Port

This menu allows the user to conﬁgure the speciﬁc port with which they

will remotely access and view the SNMPWEBCARD.

Other manuals for Tripp Lite SRCOOLNET