5
Note: Install the driver on your computer before connecting the
display adapter(s).
1. Insert the driver CD into your computer’s CD-ROM drive.
The setup program should run automatically. If the setup
program fails to start on its own, open the CD and double-
click on the appropriate driver file.
Note:
• If you encounter a User Account Control popup, choose
to allow the installation to proceed. This may require
an administrator’s password. If you encounter a driver
signature dialog box, choose to continue the installation.
• If a message stating “Display Link software for USB
display adapter is already up to date,” then the necessary
software for this unit is already installed, and you can
proceed to step 5.
2. Follow the prompts that appear to complete the process.
3. When this process is complete, you will need to restart your
computer to finish the installation.
4. After restarting your computer, connect the built-in USB 3.0
cable to an available USB 2.0 or 3.0 port.
5. Connect your display adapter to a monitor using a VGA
cable.
2. Installation
15-03-011-933433.indd 5 3/16/2015 3:47:19 PM