To Next PageTo Next Page
Need help?Do you have a question about the Triumph 2011 Tiger 800 and is the answer not in the manual?
General| Engine Type | Liquid-cooled, 12 valve, DOHC, in-line 3-cylinder |
|---|---|
| Engine Capacity | 799cc |
| Bore x Stroke | 74.0 x 61.9 mm |
| Compression Ratio | 11.1:1 |
| Fuel System | Multipoint sequential electronic fuel injection |
| Final Drive | O-ring chain |
| Clutch | Wet, multi-plate |
| Gearbox | 6-speed |
| Frame | Tubular steel trellis frame |
| Front Brakes | Twin 308mm floating discs, Nissin 2-piston sliding calipers |
| Rear Brakes | Single 255mm disc, Nissin single piston sliding caliper |
| Front Tyre | 100/90-19 |
| Rear Tyre | 150/70 R17 |
| Fuel Tank Capacity | 19 litres |
| Max Power | 94 bhp (70kW) @ 9, 300rpm |
| Max Torque | 79Nm @ 7, 850 rpm |
| Exhaust | Stainless steel 3 into 1 exhaust system |
| Front Suspension | 43mm upside down forks |
| Rear Suspension | Monoshock with adjustable preload |
| Front Wheel | Cast aluminium alloy 19 x 2.5in |
| Rear Wheel | Cast aluminium alloy 17 x 4.25in |
| Dry Weight | 210kg |
Procedures for camshaft removal, installation, and valve clearance adjustment.
Steps for dismantling the clutch and inspecting friction plates, steel plates, and pack height.
Details on oil specifications, level checks, and oil/filter replacement.
Details on frame fixings and the sequential steps for engine removal.
Procedures for reinstalling the engine, including frame and bolt tightening.
Explains the EMS function, sensors, and actuators.
Guidance on using the diagnostic tool and interpreting fault codes.
Details on coolant type, freezing point, and level inspection.
Steps for draining, refilling, and bleeding the cooling system.
Covers chain lubrication, adjustment, inspection, and replacement.
Guidance on inspecting forks for damage and procedures for removal.
Detailed steps for dismantling and reassembling the front fork components.
Procedures for checking, adjusting, and replacing headstock bearings.
Information on brake fluid level inspection, replacement, and safety precautions.
Procedures for removing, inspecting, and installing front brake pads and calipers.
Procedures for removing, inspecting, and installing rear brake pads and calipers.
Explanation of the ABS system, its components, and diagnostic procedures.
Table of ABS fault codes and their corresponding troubleshooting actions.
Procedures for removing, installing, and checking the front wheel.
Steps for removing, installing, and checking the rear wheel.
