To Next PageTo Next PageHow to troubleshoot a Triumph Automobile Accessories machine that does not turn on?
If your Triumph Automobile Accessory machine doesn't turn on, the issue might be related to the electrical wiring. Inspect the on/off switch, verify all wire connections, and trace the electrical current to identify any potential errors.
Why does my Triumph Automobile Accessories machine keep asking for more weight?
If your Triumph Automobile Accessories machine keeps asking for more weight, it could be due to several reasons. Ensure the machine is properly calibrated. Verify that the wheel parameters are entered correctly, keeping in mind that these parameters are not saved when the machine is turned off. Also, inspect the weight sensor board for any broken parts or loose wires.
What to do if Triumph NTB-1200 Automobile Accessories machine overheats and shuts down?
If your Triumph Automobile Accessories machine overheats and shuts down automatically, the transformer might be overheating or the power board could be defective. Check the temperature of the transformer when the machine shuts down. If it's extremely hot, it needs replacement. If the transformer isn't hot, the power board likely needs to be replaced.
What does error code Err 02 mean on a Triumph Automobile Accessories machine?
If you're seeing 'Err 02' on your Triumph Automobile Accessories machine, it means the rotating speed is too low for the machine to function correctly. You can try to tighten the drive belt, check the spin shaft to ensure it's tight and spinning properly, and verify that the motor is functioning correctly. You might also need to use a heavier wheel, as the machine is designed for balancing full-size car and truck tires, not smaller tires like those on ATVs.
What causes a Triumph NTB-1200 Automobile Accessories machine to trip the electrical breaker?
If your Triumph Automobile Accessories machine trips the electrical breaker, the transformer or power board may be defective. Consider replacing the power board or the transformer to resolve this issue.
What does error code Err 01 mean on a Triumph NTB-1200 machine?
If your Triumph Automobile Accessories machine displays 'Err 01', it means the guard was not closed when you tried to spin a wheel, or you raised the guard while the wheel was spinning. You can adjust the system settings to turn guard control to OFF. Avoid raising or lowering the guard while the wheel is in motion.
How do I fix Err 03 on a Triumph NTB-1200 Automobile Accessories?
If you are getting 'Err 03' on your Triumph Automobile Accessories machine, and you are using a 3 phase motor, you should adjust the three phase wires.
General| Brand | Triumph |
|---|---|
| Model | NTB-1200 |
| Category | Automobile Accessories |
| Language | English |
