The guard was not closed
when attempting to spin a
wheel or the user raised the
guard while the wheel is
spinning.
Use the system settings to
turn guard control to OFF.
Do not raise or lower the
guard while wheel is
spinning.
Rotating speed is too low
for machine to work.
Tighten the drive belt.
Check to make sure the spin
shaft is tight and properly
spinning. Check to make
sure the motor is
functioning properly. Put a
heavier wheel. Machine is
for balancing full size car
and truck tires, not ATV or
smaller tires.
The rotation is in the wrong
direction.
Occurs when using a 3
phase motor. Adjust the
three phase wires.
The machine is not
calibrated.
Follow the calibration steps.
Factory Maintenance Error
Machine Continues to ask
for more weight
Machine is not properly
calibrated, wheel
parameters where not
entered correctly, or weight
sensor board is defective
Calibrate the machine
properly. Enter wheel
parameters correctly
(remember that when the
machine is turned off, the
wheel parameters are not
saved). Check weight
sensor board for broken
parts or loose wires.
Machine trips electrical
breaker
Transformer or Power
Board are defective
Replace the power board or
transformer
Machine seems to overheat
and shut down
automatically
Transformer is overheating
or power board is defective
Check temperature of
transformer at the time the
machine shuts down. If
transformer is extremely
hot, then it must be
replaced. If transformer is
not hot, then power board
needs to be replaced.
Error in electrical wiring
Check on off switch. Check
the connection of all wires.
Trace electrical current.
To Next Page
Loading...