Triumph NTO-10A - Symbols in this Manual

Page 4 of 20
BOLT BOX CONTENTS
Cable
 33’7” Long
 7.25” (thread and blank)
 4 5/8 Thread
 Cable 5/16
 ½ Stud Threaded
 Hole for cable is 5/8 (so can’t use 3/8” Cables)
 2 nuts 2 washers
TOOLS TO INSTALL
 Hammer Drill
 ¾” Carbide Drill Bit
 Various wrenches, pliers and screwdrivers
 Block of Wood
 Hammer
 Torque Wrench
 Tall Ladder
 Fork Lift or other method of raising columns and toprails
 Electrical connectors to connect 220 volt power unit (use Qualified Electrician)
 Level
 Chalk Line
 Good O-ring Pliers
 Grease for column
 Chain oil for chains
 Vacuum to clean dust from anchor holes
 Rags
 Allow at least 3-4 hours to set up lift.
SYMBOLS IN THIS MANUAL
Failure to comply with instructions could result in personal injury.
Failure to comply with instructions could result in property damage.
Important Information