1017
4. Slowly apply rear brake pedal and maintain that pressure for approximately five
seconds. Slowly release the lever, and leave for 30 seconds. Repeat three times.
Perform the following operations:
• Rear Wheel - Installation
Additional Bleeding (if required)
1. Remove the rear wheel (see Rear Wheel - Removal).
2. Remove the rear caliper fixings and move the caliper 10° anticlockwise on the brake
disc.
Rear Brake Caliper Moved 10° Anticlockwise
3. Remove the rubber cap from the rear bleed screw.
4. Attach a transparent tube to the bleed screw.
5. Place the other end of the tube in a suitable receptacle containing new brake fluid.
6. Slowly apply and slowly release pressure to the brake pedal five times, maintaining
pressure on the final application.
To Next Page
Loading...
