1036
Further Diagnosis
Pinpoint Tests
Pin point tests, if used correctly, help to diagnose a fault in the system once a diagnostic
trouble code has been stored.
Before Starting Pinpoint Tests:
1. Delete the stored DTCs.
2. Switch the ignition OFF and ON.
If the ABS is not functioning, the brake system will continue to function as a non-ABS
braking system. Do not continue to ride for longer than is necessary with the indicator
light illuminated. Ride with extreme caution when performing diagnostic
troubleshooting on a non-functioning ABS system. In this situation braking too hard
will cause the wheels to lock resulting in loss of motorcycle control and an accident.
3. Ride the motorcycle at a road speed in excess of 30 km/h. If the DTC is repeated,
proceed to the relevant pinpoint test.
4. If the DTC is not repeated, this indicates the DTC may have been stored due to
external influences such as bad road surfaces or electrical interference.
After Completion of Pinpoint Tests:
1. Delete the stored DTCs.
2. Switch the ignition OFF and ON.
3. Ride the motorcycle at a road speed in excess of 30 km/h. If the DTC is repeated,
proceed to the relevant pinpoint test.
4. If a DTC is stored, there is a further fault. Read the stored DTC and refer to the
relevant pinpoint test.
To Next Page
Loading...
