1093
Removal and Installation - Rear Brakes Components
Rear Brake Pads – Removal
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Do not allow a brake component to hang unsupported on the brake hose or line.
Brake hoses or lines that are not supported may become damaged or bent.
Bent or damaged brake hoses or lines lead to reduced braking efficiency causing loss
of motorcycle control and an accident.
Perform the following operations:
• Rear Wheel - Removal
Note the position and orientation of the pad retaining pin clip, anti-rattle spring and
brake pads for installation.
5. Remove the clip from the brake pad retaining pin.
To Next Page
Loading...
