Triumph Rocket 3 GT 2021 - Page 1164

1126
Rear ABS Pulser Ring – Inspection
1. Check the pulser ring for damaged, missing or cracked teeth or distortion. Renew the
pulser ring as necessary.
Rear ABS Pulser Ring – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
1. Fit the pulser ring to the bearing housing and tighten the new fixings to 4 Nm.
1. Fixings
2. Pulser ring
Perform the following operations:
• Cush Drive - Installation