Triumph Rocket 3 GT 2021 - Page 1204

1166
10. Taking care not to damage the pulser ring and bearing housing, use a rubber faced
mallet to gradually and evenly remove the bearing housing assembly.
1. Fixing
2. Bearing retaining plate
3. Bearing housing
4. Bearing
5. Dowel (one of five)
Cush Drive – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
1. Taking care not to damage the pulser ring and bearing housing, use a rubber faced
mallet to gradually and evenly fit the bearing housing assembly.