Triumph Rocket 3 GT 2021 - Page 1212

1174
10. Release the four fixings and the hardened washers. Remove the rear bevel box and
discard the fixings.
1. Fixings (three of four shown)
2. Rear bevel box
Rear Bevel Box – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Perform the following operations:
NOTICE
If a stud fitted to the rear bevel box becomes loose when the fixings are removed, a
new stud must be fitted.