1310
Keyless ECM Diagnostic Trouble Codes
Diagnostic Trouble Codes (DTCs) are logged in the keyless ECM memory when there is a
confirmed fault in the system.
The codes are reported to the Triumph diagnostic tool as a four digit code.
When the system detects a fault, it begins to count the number of times the fault occurs
before confirming the fault and storing a fault code. A confirmed fault may be indicated
by the effected system(s) simply becoming inoperative, or by the illumination of a
system warning light and/or instrument warning message.
Similarly, if a fault clears, the keyless ECM also records this fact and will extinguish any
warning lights or instrument messages and restore normal operation to the affected
system, when sufficient no-fault ignition switch cycles have taken place. Any fault codes
will remain in the keyless ECM memory until the required number of no-fault ignition
switch cycles have taken place. The number of ignition switch cycles required to restore
normal operation will always be less than the number required to remove a DTC from
the keyless ECM memory. DTCs can be removed at any time using the Triumph
diagnostic tool.
To Next Page
Loading...
