Triumph Rocket 3 GT 2021 - Page 1371

1333
Keyless ECM Parameters Reset to Default
Fault
Possible cause
Action
C1130
Keyless ECM
parameters reset to
default
Download the latest keyless ECM calibration
to ensure correct model specific configuration
Erase stored DTCs from all ECMs
Electronic Steering Lock Internal Faults
Fault
Possible cause
Action
C1136
Electronic steering lock ID
incompatible Electronic steering
lock not paired to chassis ECM
Pair the electronic steering lock to
the chassis ECM (see Pairing the
Electronic Steering Lock)
C1137
Electronic steering lock internal
Error
Erase DTC
Turn the ignition off then On
Repeat if fault reoccurs
If the fault fails to clear after
repeated attempts, replace the
electronic steering lock
C1138
Electronic steering lock motor
fault
C1140
Electronic steering lock
Intermediate stop
C1141
Electronic steering lock
operation time out
Cc1144
Electronic steering lock software
fault
C1142
Electronic steering lock internal
switch fault-both switches ON
Electronic steering lock has not
fully engaged or disengaged
Erase DTC
Turn the ignition off then On
Make sure steering is positioned at
left hand full lock, such that it is not
obstructing or restricting movement
of the steering lock pin
Attempt to lock and unlock the
electronic steering lock
If the fault fails to clear after
repeated attempts, replace the
electronic steering lock
C1143
Electronic steering lock internal
switch fault- both switches OFF
Electronic steering lock has not
fully engaged or disengaged
C1145
Incorrect chassis ECM calibration
– electronic steering lock
detected but not expected
Download the correct chassis ECM
calibration to ensure correct model
specific configuration
C1146
Electronic steering lock - lock
conditions not
correct, ABS message missing
ABS fault
CAN communication fault
Check ABS DTCs and rectify as
necessary