1506
Neutral Position Adaption
The neutral position adaption is required to allow for manufacturing tolerances of the
gearbox and gear position sensor. The motorcycle is delivered from the factory with the
neutral position fully adapted.
The neutral position adaption must be reset and re-adapted under the following
conditions:
• If a gear position sensor malfunction occurs (DTC P0914 and P0917, see Gear
Position Sensor).
• The gear position sensor has been removed or disconnected for any reason.
Adaption Reset
The Gear Position/Neutral Position Adaption Reset function provided in the Triumph
diagnostic tool will erase all previous Gear Position/Neutral Position Adaptions.
To reset the Neutral Position adaptions:
1. Connect the Triumph diagnostic tool and turn the ignition ON.
2. Select ENGINE DIAGNOSTICS.
3. Check and erase any stored DTCs.
4. Select ADJUST then select Gear Position/Neutral Position Adaption Reset.
5. Click Start.
6. The software will confirm that the adaption has been successfully reset.
7. The neutral position will now be reported as Not Adapted.
Re-Adaption
Exhaust fumes are poisonous, always operate a motorcycle in the open-air or in an
area with adequate ventilation.
Do not operate a motorcycle in an enclosed area without adequate ventilation.
Operating a motorcycle in an enclosed area without adequate ventilation can cause
loss of consciousness and death within a short period of time.
To Next Page
Loading...
