1512
Shift Force Sensor Adaption (if fitted)
The shift force sensor adaption is required to allow for manufacturing tolerances of the
shift force sensor.
If Triumph Shift Assist is fitted as standard, the motorcycle is delivered from the factory
with the shift force sensor fully adapted.
If the Triumph Shift Assist has been fitted as an accessory, the shift force sensor must be
adapted as part of the accessory kit installation process.
The shift force sensor adaption must be reset and re-adapted under the following
conditions:
• If a shift force sensor malfunction occurs (DTC P1702 and P1703, see Shift Force
Sensor Circuit (Triumph Shift Assist)).
• If the shift force sensor has been removed or disconnected for any reason.
Adaption Reset
The Shift Force Sensor Adaption Reset function provided in the Triumph diagnostic tool
will erase all previous shift force sensor adaptions.
To reset the shift force sensor adaption:
1. Connect the Triumph diagnostic tool and turn the ignition ON.
2. Select ENGINE DIAGNOSTICS.
3. Check and erase any stored DTCs.
4. Select ADJUST then select Shift Force Sensor Adaption Reset.
5. Click Start.
6. The software will confirm that the adaption has been successfully reset.
7. The Shift Force Sensor Adaption Status will now be reported as Not Adapted.
To Next Page
Loading...
