Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Perform the following operations:
• Seat – Removal
• Battery – Removal
• Evaporative Canister – Removal
• Ignition - Removal
1. Using a suitable tool remove the spark plugs from the cylinder head.
1. Spark plug (two of six shown)
2. Check for signs of abnormal discolouration or deposits (see Spark Plugs -
Inspection).
3. Check and if necessary adjust the spark plug gap to 0.9 mm +0.0/-0.1 mm.
4. Refit the spark plugs or, if required, fit new spark plugs and tighten to 12 Nm.
To Next Page
Loading...
